On the blow molder, uneven preform heating isn’t just a speed killer—it’s a scrap generator. When the heating tunnel can’t hold repeatable temperature across every cavity, you end up with thin walls, stress cracks, and fill weights that drift all over the place. The SIDEL 2002406262 lamp is built to put the thermal control back where it belongs: inside the machine’s original design envelope. What matters technically The 2002406262 is a short-wave infrared halogen emitter, specced to match the OEM heating profile for PET stretch blow molding. It runs on standard line voltage, responds fast for quick cycle recovery, and holds stable output inside the heating tunnel. The quartz envelope and R7s connector interface match the original lamp footprint, so you can swap it in without touching the reflector or the wiring harness. Why it works on your floor This lamp drops straight into SIDEL machines across the Matrix and Contiform lines, and it also fits heating modules on HyPET systems. That kind of compatibility means one engineered replacement can cover multiple platforms in the same plant. The payoff is predictable preform heating, fewer rejects tied to temperature swings, and uptime you can actually plan around. In practice, that shows up as more consistent bottle weight, better clarity, and fewer unplanned stops. Things to keep straight on install Installation is straightforward, but alignment is where people get tripped up. If the lamp sits off-center in the reflector, you’ll see hot and cold bands across the preforms. During changeover, verify connector seating and make sure the reflector is clean. And remember—this is a halogen infrared emitter, so it runs hot. Always confirm cooling and shielding are intact before you energize.