Replacement lamp for SIG Blomax 4

Thu, 09 Jul 2026 07:29:00 +0800

Why the Right Lamp Makes All the Difference on a Sidel Matrix

Let’s talk about what happens when you replace the infrared lamp on your Sidel Matrix. The machine is smart. It’s already set up to run with a specific thermal rhythm. So when you swap in a lamp that wasn’t built for it, you’re asking for trouble. We built this replacement specifically for the SIG Blomax 4 to keep that rhythm intact. The whole point? You pop it in, and the heating profile just… stays the same. No messing around with re-tuning. No scrambling to stop the line. It’s a direct fit, plain and simple. The specs are exact because the machine expects them. We’re talking 400V, 2500W—the exact power density the Matrix was designed for. The lamp is 300mm long with a 25mm tube, the same size as the original. That means the reflector does its job perfectly, focusing the heat right where it needs to be.

Replacement lamp for SIG Blomax 4/6/8

Sun, 28 Jun 2026 04:40:11 +0800

On a stretch blow molding line that’s running hot, heating drift in the preform tunnel isn’t just a throughput hit—it’s a quality hazard that shows up fast. When the SIG Blomax 4/6/8 runs with weak or uneven infrared output, you get short shots, stress marks, and scrap that climbs every shift. We built this replacement lamp to bring the heating profile back to what the machine was designed for, so you can hold cycle time and PET wall distribution without throwing temperature fixes at the problem. What matters under the hood We build this emitter as a true 1:1 match for the Blomax 4/6/8 heating tunnel geometry, using short-wave infrared halogen elements in a quartz tube. That gives you fast response and stable radiant heat. It’s rated for standard line voltages, with the right length, arc position, and R7s base/connector interface, so it drops straight into the existing fixtures—no mods. Watt density is sized to match the original thermal map across the preform shoulder and body, so heat-up is repeatable without hot spots that trigger crystallization or cold zones that cause brittle blow-outs. Here’s why it holds up in real PET stretch blow molding: timing is everything. This lamp returns the machine to its intended thermal behavior, which keeps parison stretch stable and bottle weight consistent. The payoff is fewer micro-adjustments, fewer jams, and less downtime spent swapping lamps. Energy use stays predictable because the output curve tracks the OEM baseline, and the quartz envelope plus solid terminations support normal service intervals—meaning fewer late-night callouts. Installation is straightforward, but remember the heating tunnel is a harsh environment. Keep the lamp ends clean, make sure it’s seated properly, and verify reflector condition so irradiance stays uniform. Also, match the lamp to the exact Blomax 4/6/8 variant and voltage configuration. Even if a mismatched wattage or length physically fits, it can shift the heat profile enough to hit bottle quality.

4 on Warm Home Infrared Heating Solutions

Replacement lamp for SIG Blomax 4

Why the Right Lamp Makes All the Difference on a Sidel Matrix

Replacement lamp for SIG Blomax 4/6/8