Replacement lamp for SIDEL SBO Series 2

Tue, 21 Jul 2026 09:02:28 +0800

Stop the Headache of Thermal Instability in Your Sidel SBO Series 2

Here is the truth about swapping out infrared lamps in a Sidel SBO Series 2: the biggest nightmare is a power mismatch. If your new tubes aren’t a perfect match for the original wattage and voltage, you’re asking for trouble. You’ll end up with uneven heat across the preform, which means wonky wall thickness and—you guessed it—bottles that just fail. The deal with power matching We make these lamps to hit the OEM specs exactly. In a rotary blowing machine, the heating profile is incredibly tight. Even a tiny 5% slip in wattage can create “cold spots” or burn certain zones. We’ve dialed in the filament density so the heat flux stays steady across the whole tube. It’s a simple drop-in replacement. You won’t have to spend your afternoon messing around with oven controllers just to get things running right. Quartz and the nitty-gritty We use high-purity quartz glass because it can take the punch of rapid thermal cycling without cracking. As for the wiring? We stick to standard industrial connectors—usually R7s or SK15. You just plug them in. No hacking, no modifying lamp holders, no stress. Plus, the shortwave IR emission is tuned specifically so the PET actually absorbs the heat. The trade-off you need to know about High-wattage tubes are great for high-speed production, but they come with a catch. Running them at full tilt puts a lot of pressure on your cooling fans. If your vents are clogged or your fans are on their last legs, that ambient heat builds up. That’s how you kill a lamp prematurely. Do yourself a favor: keep your airflow clear. It’ll save you from an unplanned shutdown. Matching that power profile is really the only way to stop those annoying heating fluctuations. It keeps your preform temperature steady and keeps your scrap pile small.

Sidel SBO 16 Series 1 heating tube

Wed, 03 Jun 2026 11:51:26 +0800

On a blow molding line, the heating tunnel is where the rubber meets the road. Every minute of downtime, every off-spec bottle, usually traces back to temperature control. If you’re running a Sidel SBO 16 Series 1, the infrared heating tube has to behave like the original. Otherwise the preform profile drifts, and the machine ends up fighting itself. What matters under the hood We build the Sidel SBO 16 Series 1 heating tube as a direct-fit replacement, right down to the wattage density, dimensional reach, and mounting. Short-wave infrared gives you fast response, so the tunnel recovers quickly after a jam clears and you restart without a long warm-up drift. The quartz envelope and halogen filament are chosen to hold stable output across the tube life, and the terminations match the machine’s connector interface for a secure, repeatable install. In stretch blow molding, repeatability is the scoreboard. Tighter control of preform heating keeps wall distribution consistent and cuts rejects. The fast response also helps keep cycle times steady, because the tunnel gets back to setpoint fast after interruptions. In practice, that means fewer heating-related stops, less scrap, and lower energy per bottle. Installation is straightforward, but the heating tunnel is a harsh environment. Keep the reflector clean and double-check alignment so the heat profile stays centered on the preform path. Match voltage and wattage to the original spec; stray outside the rated range and you’ll shorten tube life and throw off the heating curve. For full compatibility, use the correct connector type and confirm your SBO 16 Series 1 firmware and sensor setup are calibrated to the OEM settings.

Series on Warm Home Infrared Heating Solutions

Replacement lamp for SIDEL SBO Series 2

Stop the Headache of Thermal Instability in Your Sidel SBO Series 2

Sidel SBO 16 Series 1 heating tube